Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
To fill the dispenser, open the cap and pour
the rinse aid into the dispenser until the level
indicator turns completely black. The volume of
the rinse aid container is about 140ml.
Be careful not to overfill the dispenser, because
this could cause oversudsing. Wipe away any
spills with a damp cloth. Do not forget to replace
the cap before you close dishwasher door.
Attention!
Clean up any rinse aid split during filling with
an absorbent cloth to avoid excess foaming
during the next wash.
Adjusting Rinse Aid Dispenser
The rinse aid dispenser has four or six settings .
Always Start with the dispenser set on «4» If
spots and poor drying are problems, increase the
amount of rinse aid dispensed by removing the
dispenser lid and rotating the dial to «5». If the
dishes still are not drying properly or are spotted,
adjust the dial to the next higher number until
your dishes are spot-free. The dose is factory set
in position 5.
GB-22
Publicité
