FoodSaver VS1190X Guide De Référence page 9

Problem
Cannot insert a bag into the
vacuum sealer.
Air was removed from the bag, but
now air has re-entered.
The bag has melted.
FoodSaver Container does not
®
vacuum.
If you need further assistance:
Care and Cleaning of your Vacuum
Sealer
To Clean Appliance:
Remove Power Cord from electrical outlet. Do not immerse in liquid.
Check Gaskets and around Drip Tray
G H
are free from food materials. Wipe off Gasket
soapy cloth if needed. Upper and Lower Gaskets
removed for cleaning. Clean with warm, soapy water.
The Removable Drip Tray
K
amounts of liquids are pulled into the Vacuum Channel
vacuum process.
Empty Drip Tray after each use. Wash in warm soapy water or
K
place on top rack of dishwasher. Dry thoroughly before re-inserting
into the appliance.
9
Solution
• Make sure that there is enough bag material to reach the centre of the drip tray.
Always allow about 75mm extra space to allow the bag to seal tightly around the
food contents.
• Gently stretch the bag flat while inserting into the vacuum channel. Make sure
that the end of the bag curls down into the vacuum channel.
• Examine the seal. A wrinkle along the seal may cause air to re-enter the bag. To
prevent wrinkles in the seal, gently stretch the bag flat while inserting bag into the
vacuum channel.
• Moisture or food material (such as juices, grease, crumbs, powders) along the seal
prevents the bag from sealing properly. Cut the bag open, wipe the top inside of
the bag and reseal.
• Sharp food items may have punctured the bag. Use a new bag if there is a hole.
Cover sharp food items with a soft cushioning material, such as a paper towel, and
reseal.
• Fermentation or the release of natural gases from inside the foods may have
occurred. When this happens, food may have begun to spoil and should be
discarded.
• The sealing strip may have become too hot. Always wait at least 20 seconds for
the appliance to cool down before you vacuum seal another item.
• Use FoodSaver
for FoodSaver
• The lid of the container must be correctly placed on and aligned to the container.
• Make sure you press the Accessory button.
• Please visit www.foodsaver.co.uk or contact FoodSaver
Service on 0800 525
to make sure they
K
with warm
G H
may be
G H
makes clean-up easy when small
during
J
www.foodsavereurope.com
brand bags. FoodSaver
®
appliances.
®
089.
To Store Appliance:
Clean unit thoroughly as detailed above.
After the unit has been cleaned and allowed to fully dry, close lid and
slide the Lock Latch
prevents any undue pressure from being applied to the internal
sealing gaskets
Always leave lid latch in open position
store lid in OPERATE position
compressed and the unit may not function properly.
Bags and Rolls are specially designed
®
Brand Customer
®
into the open (top) position
E
of the unit.
G H
when not in use. Never
C
as gaskets
D
. This setting
C
may become
G H