Procedure - Bosch HDI8054C Mode D'emploi

Procedure

Convert Pressure Regulator from
6" W.C. to 11" W.C.
1. To remove the warming drawer; pull the drawer out
until stop is reached. Facing the range, push clip on left
side up and clip on right side down. Pull drawer the rest
of the way out.
2. Remove cover plate from interior back wall by
removing single screw on left side of panel. Use a Torx
T-20 head screwdriver.
3. Remove the hexagon cap from the top of the regulator
with an adjustable wrench.
4. Pop out the plastic stem in the cap and turn it over
pressing it firmly in place so that the letters LP (rather
than NAT) are seen upright in the stem.
Replace the cap and button assembly into the top
of the regulator sealing it firmly. Make certain
spring is still in place. DO NOT OVERTIGHTEN!
Pin Position
for Propane
LP
Pin
Position
LP
for Nat.
Gas
Hex
Cap
Pin
NA
NAT T
PRESSURE REGULATOR VIEW
5. Fill out and affix the CONVERSION STICKER on the
back side of the cover plate so that it appears on the
back side of range next to the regulator.
English 4
Hex
Cap
Pin
Spring
Change Cooktop Orifices
1. Remove grates, burner caps and burner bases.
Unscrew two (2) T20 screws inside each base and
remove burner bases. Reinsert screws in jet holder to
hold tubing assembly in place.
Burner Grate
Burner Cap
Burner Base
Orifice
2. Remove natural gas cooktop orifices.
Insert the socket driver with 3" (76mm) minimum
extension into the jet holders to remove existing
orifices. Set natural gas orifices aside.
Note: The orifices require a 7 mm socket driver for removal/
replacement. The driver will need to be inserted approxi-
mately 2 1/2" (64 mm) into the burner cavity to reach the
orifice.
Hint: To reduce the chance of the orifice being dropped
from the socket driver, add a piece of foam tape or
adhesive tape inside the socket.
a) Trim a small piece of the foam tape provided with
this kit (about 1/4" x 1/2"; 6mm x 12mm).
b) Fit this so the tape wraps against one side of the
socket so it stays in place.
c) When pressing the socket driver onto the orifice,
the tape will fit to the orifice and help prevent the
orifice from falling out of the socket during
extraction.
Ignitor
9001080874 Rev A