Conversion; Before You Begin - Bosch HDI8054C Mode D'emploi

Conversion

Before You Begin

Tools and Parts Needed
• 7 mm Socket Driver w/ 3" (76mm) extension
• Torx (T20)-head screwdriver
• Adjustable Wrench
• Flathead Screwdriver (1/8" (3.17mm)or smaller)
• Phillips Head Screwdriver
Parts Included
• Conversion Kit Instructions
• Conversion Sticker
• LP Orifices
- 6 for Gas Slide-in Range
- 7 for Dual Fuel Slide-in Range
• 1 Broil Orifice Hood (models that are all gas only)
• LP Conversion Jig (models that are all gas only)
• Foam tape
Note: This manual supports two different Slide-In Range
models (dual fuel and gas), thus some parts listed may not
be present if it doesn't pertain to the model purchased.
9001080874 Rev A
General Information
Always Provide Adequate Gas Supply
This appliance is shipped from the factory for use with
natural gas. Use this kit to convert the appliance for LP gas
use if necessary. Observe the following:
Be sure the range is converted for use with the appropriate
gas before using it.
This appliance is designed to operate at a pressure of 10"
of water column when used with LP gas.
When checking for proper operation of the regulator, the
inlet pressure must be at least 1" greater than the operating
(manifold) pressure above. When converting for LP gas
use, the pressure supplied to the regulator must be
between 11" and 14" of water column.
The pressure regulator located in the inlet of the range
manifold must remain in the supply line.
Use a flexible metal appliance connector or rigid pipe to
connect the range to the gas supply. The connector should
have an inner diameter of 1/2" and be 5' or less in length.
(Exception: Maximum connector length in Massachusetts
installations is 3'). In Canada, the connector must be
single-wall metal and not longer than 6'.
Preparation
m
CAUTION
Turn off gas and electricity.
Before proceeding with the conversion, shut off the gas
supply to the appliance prior to disconnecting the electrical
power.
1. Turn all control knobs to the OFF position.
2. Shut off the outside propane tank gas valve to the
range.
3. Remove range power cord from electrical outlet or turn
breaker off at breaker box.
English 3