Christopeit Sport TM650S Notice De Montage Et D'utilisation page 17

Displays:
ENTFERNUNG (DISTANCE) - Display:
Shows the distance you run in kilometers.
KCAL / PULS
shows the approx. consumed kilocalories in KCAL and the heart rate in
alternation every 6 seconds.
ZEIT (TIME) - Display:
Shows the time of exercising in minutes.
GESCHWINDIGKEIT (SPEED) - Display :
Shows the speed of the treadmill in kilometers per hour.
Key-Function:
[START]-Key:
Press this key to start exercise program (motor starts running).
[STOP/PAUSE]- Key:
Press this key during exercise to interrupt the program (motor stops
running). Within 5 min. you can press [START]-key again to continue this
exercise program or press [STOP]-key again to finish this program. Pre-
values can set to zero by pressing the [STOP] - key.
[EINGABE] -Key (ENTER):
Select key of Time-program, Distance-program or Calories-program.
[PROG.]-Key (Programs):
Press this key to select exercising programs P1- P15.
[+]-Key:
Press speed up -key increase settings or motor speed.
[-]-Key:
Press speed down -key decrease settings or motor speed.
Quick Speed -keys 4 and 8 km/h
Press one of these keys and the speed changes direct into 4 or 8
User manual of Computer
Remote keys:
The functions can be activated using the remote keys on the handles
Start/Stop and +/- can be controlled in the same way as on keys at com-
puter.
Manual
How to start manual mode:
Put in the AC plug in wall power 220V-240V, 50HZ-60HZ and put on the
power switch. Put safety clip on to the computer and it will show normal
manual mode. Stand your feet on both side rails. Put the safety key at
you exercise cloth and press [START]-key to start with exercising. After a 3
sec. count down, the mo tor begin to run slowly and you can step on the
running belt and follow the speed. Adjust the speed with [+/-]- keys into
desired speed. If put off the safety clip from computer at any time, the
motor stop slowly and the display will show „---". After put on the safety
key on computer the normal manually program will show. Press [+/-] key
to adjust value of speed. Press quick speed key to adjust speed quickly.
All values of the displays will counter up.
Time-Program:
Press the [EINGABE]-key once and the time display lights up. [ZEIT/PULS]
-Display shows a suggestion of 30:00 minutes. Press [+/-]-key to set value.
The range is: 5:00-99:00min. If set a value the display counts up till zero
and then stops running motor.
Distance-Program:
Press the [EINGABE]-key until the distance lights up. [DISTANCE/CAL]
Display shows a suggestion of 1:00 km/h. Press [+/-]-key to set value. The
range is: 0,50- 99:90KM. If set a value the display counts up till zero and
then stops running motor.
Calories-Program:
Press the [EINGABE]-key until the KCAL lights up. [DISTANCE/CAL] Display
shows a suggestion of 50,0 kcal. Press [+/-]-key to set value. The range is:
10-990 kcal. If set a value the display counts up till zero and then stops
running motor.
17