Publicité
Les langues disponibles
Les langues disponibles
Maintenance and adjusting
1. Lubrication for the running belt:
In order to keep the machine in the best condition, please add some
Silicone oil between the running belt and the running board after 50
hours or 1 to 2 month of use. But the running belt may slip, if you
lubricate too much. To lubricate the belt please pull the walking belt
up and injection the silicone oil into the gap between belt and walking
deck.
2. Adjusting running belt:
You need to adjust the walking belt to the normal position, per the
following steps if it is off.
1. Set speed at 3-5km.
2. Using the Allen wrench for running belt adjustment (12) to adjust
the belt tension bolt on the end cap of the system frame.
3. If you want to move the belt towards left, turn the right tension bolt
clockwise.
4. If you want to move the belt towards right, turn the left tension bolt
clockwise.
5. If you have already done according to the steps above and it is
still not at the good range, then the running belt should be damaged
already, please contact your local dealer for replacement.
Note: Make sure that the running surface is as centered as possible. Once these
moves too far from the center, (about 10 mm) it should be readjusted into the center.
3. Running belt slips:
1. Make sure the walking belt is not too loose.
2. Make sure the motor belt is not too loose.
4. No light on the Display:
1. Check if the power plug is properly connected.
2. Check if the safety key on the computer is in place.
3. Check if the wire in the right post is properly connected.
Remind ! Before you inspect any wire or electrician part, please ensure
that the Power supply has been turned off.
5. Abnormal noise from the machine
1. Check if any screw of machine is loose.
2. Check if the motor belt is off.
3. Check if the running belt is off.
Note:
Please contact your local dealer if you have checked all the above listed
things but the problem is still there.
16
Publicité
