Machine Operation (Scrubbing/Drying) - Nilfisk SC2000 Instructions D'utilisation

revised 07/2017

MACHINE OPERATION (SCRUBBING/DRYING)

1. Start the machine as shown in the previous paragraph.
2. Press the One Touch button (43) to lower the brush deck (7) and the squeegee (13) and start scrubbing and drying.
3. Start scrubbing, by starting it with both hands on the steering wheel (1) and by pressing the drive pedal (2) as necessary.
NOTE
The machine is equipped with a safety system that turns on the brush and vacuum system only when the machine is
moving.
4. Adjust the detergent flow by pressing the push-button (47) as necessary, depending on the type of cleaning to be performed.
NOTE
For the first 3 flow levels (Fig. 4), the amount of solution dispensed is automatically adjusted according to the machine
speed, in order to obtain a constant amount of solution per linear meter of cleaning.
Level 4 (when enabled) supplies the maximum possible quantity of detergent solution, regardless of the machine speed
(to enable or disable this feature, see the Supervisor key paragraph in Maintenance chapter).
The level 0 closes the solution flow completely.
Lev.
1
0,75 cl/m
5. If necessary, to reduce the noise, turn on the vacuum system mute function by pressing the push-button (44).
NOTE
For correct scrubbing/drying of floors at the sides of the walls, Nilfisk suggests to go near the walls with the right side of
the machine as shown in figure 5.
A
6. To stop scrubbing/drying, press the One-Touch push-button (43) and wait for the brush deck (7) to lift. After 10 seconds, the
vacuum system turns off too and the squeegee (13) lifts.
01/2015
Lev.
3
Lev.
2
1,5 cl/m 3,0 cl/m
Figure 4
Figure 5
INSTRUCTIONS FOR USE
Lev.
4
Lev.
0
2,8 l/min
B
9100000383 - SC2000
ENGLISH
OFF
P100866
P100867
15