Manual Data Logging - VOLTCRAFT LX-2000 Mode D'emploi

Interrupting the logging
• The data logging can be interrupted by briefly pressing the "LOG" button. The "REC" symbol will disappear and no
memory beep will be heard.
You can use the "TIME" button (7) during interruption to display the logger parameters in the bottom line.
This display function is also available in normal measurement operation (without data logger).
The display automatically switches the following parameters: year (yy), month/day (mm dd), time (h m),
interval time (SP-t xx).
• To continue logging, briefly press the "LOG" button.
Stopping the logging
• To stop data logging, press and hold down the "LOG" button for approx. 3 seconds. The "LOG" and "REC" symbols
will disappear from the display. The device will return to normal measurement display.
c) Manual data logging
The meter allows manual storage of measurement data in up to 99 memory locations. The interval time setting must
be 0 seconds. The interval time setting is described in chapter "Setup, c) System settings".
• Turn on the meter and select the respective measurement function (illumination/temperature).
Starting the data logger
• Press and hold down the "LOG" button (8) for approx. 3 seconds. "P 1" will be displayed in the bottom line. Manual
data logging is enabled.
• Use the "▲" and "▼" cursor buttons to select the desired memory location. You can adjust from "P 1" to "P 99".
• To save the measured value in the preset memory location, briefly press the "ENTER" button. The saving operation
is confirmed with the "REC" symbol and a beep.
The memory card is checked during the first storage. The display briefly shows "SCAn Sd". If a missing or
faulty memory card is detected, a warning message "Sd -E-" will be displayed with a triple warning beep. In
this case, check that the memory card is inserted correctly and functions properly.
Multiple measured values can be stored in one memory location. They are not overwritten since a time
stamp is also saved.
Stopping the logging
• To stop data logging, press and hold down the "LOG" button for approx. 3 seconds. The memory location symbol
(P 1 – P 99) will disappear from the display. The device will return to normal measurement display.
39