Warranty; Disposal - Dometic BUTTNER MT LB30 Instructions De Montage Et De Service

Fault
The charging booster
constantly switches
between active and
idle state.
The battery is no lon-
ger taking a charge or
is unable to hold a
charge.
The display panel
does not work.
The display panel
only lights up poorly.

Warranty

The statutory warranty period applies. If the prod-
uct is defective, please contact your retailer or the
manufacturer's branch in your country (see
dometic.com/dealer).
For repair and warranty processing, please include
the following documents when you send in the
product:
• A copy of the receipt with purchasing date
• A reason for the claim or description of the fault
Note that self-repair or non-professional repair can
have safety consequences and might void the war-
ranty.
Possible cause
Weak D+ signal.
Faulty connection of the starting battery.
The battery is defective.
The display panel is connected incorrectly. ➤ Check the connections (see chapter
Night mode is activated.
Suggested remedy
➤ Check the D+ signal.
➤ Alternatively use the ignition key signal
➤ Check the connections for insufficient
➤ Replace the battery.
➤ Switch off the night mode (see chapter

Disposal

Recycling products with non-replaceable
batteries, rechargeable batteries or light
sources
➤ If the product contains any non-replace-
➤ If you wish to finally dispose of the prod-
➤ The product can be disposed free of
Recycling packaging material
➤ Place the packaging material in the appro-
4445103799
(terminal 15) or install a D+ Active simula-
tor (available as accessory).
cabling and fuse protection or corrosion at
the chassis connections.
"Using the display panel" on page 18).
"Setting the night mode" on page 23).
able batteries, rechargeable batteries or
light sources, you don't have to remove
them before disposal.
uct, ask your local recycling center or spe-
cialist dealer for details about how to do
this in accordance with the applicable dis-
posal regulations.
charge.
priate recycling waste bins wherever pos-
sible.
25