Fault
Full charging current is not
reached in booster mode.
The "Batt. II" LED flashes.
Control panel only lights up
poorly.
Warranty
The statutory warranty period applies. If the prod-
uct is defective, please contact your retailer or the
manufacturer's branch in your country (see
dometic.com/dealer).
For repair and warranty processing, please include
the following documents when you send in the
product:
• A copy of the receipt with purchasing date
• A reason for the claim or description of the fault
Note that self-repair or non-professional repair can
have safety consequences and might void the war-
ranty.
Possible cause
Voltage at START+ <11 V.
Cutoff relay present.
DIP switch is set to "Limit Boo".
Night mode is activated.
4445103619
Suggested remedy
➤ Check voltage at START+. Increase
the motor speed so that the battery
control booster can regulate.
➤ Adapt connection variant for vehicles
with an existing cutoff relay.
➤ Check the position of the DIP switch
(see chapter "Reducing the current
consumption from the starter circuit in
booster operation" on page 29).
➤ Switch off the night mode (see chap-
ter "Setting the night mode" on
page 30).
Disposal
Recycling packaging material
➤ Place the packaging material in the appro-
priate recycling waste bins wherever pos-
sible.
Recycling products with non-replaceable
batteries, rechargeable batteries or light
sources
➤ If the product contains any non-replace-
able batteries, rechargeable batteries or
light sources, you don't have to remove
them before disposal.
➤ If you wish to finally dispose of the prod-
uct, ask your local recycling center or spe-
cialist dealer for details about how to do
this in accordance with the applicable dis-
posal regulations.
➤ The product can be disposed free of
charge.
33