Publicité
Les langues disponibles
Les langues disponibles
Place the unit on a sturdy, flat, dry and horizontal base near an electrical socket
and a discharge point for hot air, e.g. a window that can be opened slightly. Make
sure that the unit has at least 30 cm of free space on all sides and take all safety
instructions into account.
To dehumidify you now connect a water drainage hose to the water drain -
constant (7).
This hose should lead to a bucket or drain. The hose should not run upwards! Your
unit is now ready for use.
In order to use the cooling function, you do not need to connect the water
drainage hose. Place window panel in the window opening, see diagram. The
length of the window panel can be adjusted from 67.5 to 123 cm.
Screw on the connector for the air conditioner on one end and the connector for
the window panel on the other end of the outlet hose.
Slide the connector for the air conditioner into the appropriate slot on the rear of
the unit.
Secure the other end of the outlet hose in the window panel opening so that it can
remove hot air outside.
You can also hang the outlet hose out of an open window; this method is less
efficient however.
Avoid bends or pinches in the pipe. These will lead to a build up of damp, waste air
which can cause leaks, overheating or lead to the air conditioning unit switching
off.
Warning! Do not use your air conditioning unit until it has been installed
according to the instructions above!
Warning! Ensure that water cannot penetrate the device!
Warning! The length of the discharge pipe corresponds to the technique that is
used in this air conditioning unit. Do not replace or extend it using another pipe as
this could have a negative impact on the effectiveness of the unit. The hose can be
stretched but must be kept as short as possible in order to ensure optimum
functioning.
Don't forget about preventing access to burglars!
20
Publicité
