EUROM PAC 12.2 Wifi Livret D'instructions page 18

the plug from the socket. Device, plug and / or cable must be
repaired/ replaced by an electrician or similarly qualified person.
Repairs by inexperienced people will invalidate the warranty and can
cause dangerous situations!
Safety in relation to coolant R290
 This device contains the coolant R290. R290 is a coolant that complies
with the relevant European Directives. Never perforate the coolant
circuit. R290 is flammable (GWP 3)!
 Never use substances other than those recommended by the
manufacturer for the defrosting process.
 This device must be used and stored in a room that does not contain
sources of ignition, such as open flames or gas and electrical devices in
operation.
 Do not perforate any of the components of the cooling circuit and do
not set light to the device
 If the device is installed, working or stored in an un-ventilated you
must take measures to prevent fire or explosions caused by leaked
coolant. Ensure that there are absolutely no sources of ignition (such
as fire, heaters, sparking electrical equipment, lit cigarettes, etc.) in
the same room!
 The device must be stored in such a way that mechanical defects are
prevented.
 Do not install, operate or store the device in a room smaller than
10,1m².
 R290 is odourless, which means that you cannot smell leaks!
 Persons working on the cooling circuit must be in possession of the
correct qualifications that state the person in question is competent to
use coolant in accordance with a special evaluation that is recognised
by the sector association.The repairs must be executed on the grounds
of the recommendations of the manufacturer of the device.
Maintenance and repairs that require the assistance of other qualified
persons must be executed under supervision of someone who is
specialised in the use of flammable coolant.
Maximum effect
 Never exceed the recommended area to be cooled.
 Do not place the unit in the vicinity of a heat source or in direct sunlight.
 Close windows and doors and keep curtains or hatches closed during the sunniest
hours in the day
 Keep filters clean
 Modify temperature and ventilation settings once the area has reached the
required condition.
18