Step 3: Unpacking & Moving The Range - Thermador PROFESSIONAL PRO GRAND PRD364JDGC Instructions D'installation

When using a receptacle it may be necessary to recess the
receptacle's housing into the rear wall. Refer to Local
Electrical Code to determine the minimum volume for all
electrical / junction boxes. Follow all local electrical codes.
Mount the receptacle securely to a wall stud, then seal
around the receptacle's housing.
To minimize binding when the unit is connected, orient the
receptacle or conduit connector, and slide back into
position.
NOTE: Canadian models have the power cord supplied
with the range.
STEP 3: Unpacking and
Moving the Range
Unpacking the Range
1. Remove the outer carton and packing materials from
the shipping pallet but leave the adhesive-backed foam
layer over brushed-metal surfaces, to protect finish
from scratches, until the range is installed in its final
position.
2. Remove the door(s) (see "STEP 4: Door Removal and
Adjustment" on page 13); however, DO NOT remove
the warming drawer or steam oven doors, if applicable.
This will create an estimated reduction in the weight as
shown in Table 1 and allow the range to pass through
30" (762 mm) doorways (see clearances beginning on
page 8).
3. The grates, griddle plate, burner caps, and oven racks
must be removed to facilitate handling. Do not remove
the griddle element and tray assembly.
Shipping Weight
Weight without packing
materials
Without door(s), burner caps,
and oven racks
Installation Instructions
36" 48"
RANGE RANGE
420 lbs 590 lbs
(191 kg) (268 kg)
360 lbs 530 lbs
(163 kg) (240 kg)
260 lbs 390 lbs
(118 kg) (177 kg)
Table 1: Range Weight
Moving the Range
CAUTION
DO NOT lift the range by the oven door's
handle, as this may damage the door hinges
and cause the door to fit incorrectly.
DO NOT lift the appliance by the range's
control panel.
The unit is heavy and should be handled
accordingly. Proper safety equipment such
as gloves and adequate manpower of at
least two people must be used in moving the
range to avoid injury and to avoid damage to
the unit or the floor.
Rings, watches, and any other loose items that may
damage the unit or otherwise might become entangled
with the unit should be removed.
Hidden surfaces may have sharp edges. Use caution
when reaching behind or under appliance.
DO NOT use a hand truck or appliance dolly on the back
or front of the unit. Handle from the side only.
Due to the weight, it is strongly recommended that a
furniture dolly with soft wheels or an air lift should be used
to move this unit. The weight must be supported uniformly
across the bottom.
All ranges are held to the pallet by (4) bolts through a wood
block center. The two front pallet bolts are accessible only
after removing the Door Trim located beneath the doors.
1. Remove the door trim by loosening the 2 Torx screws
attaching it to the range. Slide the trim up and off the
screws.
Figure 7: Door Trim Removal
English 12