Thermador PROFESSIONAL PRO GRAND PRD364JDGC Instructions D'installation page 26

Installing the Leg Covers
1. Remove plastic coverings from the stainless steel
covers.
2. Place the smaller cover, with cutouts facing up, inside
the larger cover with the openings of both stacked and
facing the back.
3. Beneath the range, wrap the cover assembly around
the leg.
4. Slide the outer cover up while the inner piece remains
on the floor. The mating part has dimples for which the
holes of the larger cover should seize. You should feel
a definitive click, letting you know that the cover
assembly has been mounted to the unit.
Installation Instructions
Figure 32: Leg Covers
Figure 33: Range Dimples
5. Secure the cover assembly through the dimpled holes
with (2) ½'' stainless steel Torx head screws (included),
as shown below.
Figure 34: Leg Cover Mounting Holes
6. Repeat for all visible legs.
• If additional leg covers are required, they may be
ordered from the service center by calling
1-800-735-4328 at no charge for up to one year
after purchase date of the appliance. When
ordering, refer to Leg Cover Kit part no. 00751305.
Toe Kick Panel (optional)
(PA[36,48]JTKG)
TOE KICK PARTS
INCLUDED
1 – Toe Kick
Panel
4 – T-20 Torx
drill point screws
1. Remove the screws securing the leg covers (see
Figure 34: "Leg Cover Mounting Holes"). Dismount the
leg covers from the extruded dimples.
2. Remove protective plastic covering from the Toe Kick
Panel.
3. Beneath the range, with the holes and flange facing up,
wrap the Toe Kick Panel around the cast aluminum
base (see Figure 35).
4. The mating part has extruded dimples on both sides for
which the holes of the Toe Kick Panel should seize.
You should feel a definitive click, letting you know that
the part has been installed.
TOOLS NEEDED
T-20 Torx head
screwdriver or drill
Protective work gloves
English 25