Thermador PROFESSIONAL PRO GRAND PRD364JDGC Instructions D'installation page 24

NOTE: If a Backsplash is to be used in addition to a
backguard, install the Backsplash first and the backguard
second before sliding range into place.
Backguard Installation
1. Depending on model, remove the (3) or (5) T-20 Torx
stainless screws in the front face of the included Flush
Island Trim (Figure 26).
Figure 26: Flush Island Trim Front Face Screw Removal
2. Remove the (4) drill point screws securing the trim to
the side panels, and the (3) or (4) drill point screws
securing the piece to the back panel. Lift up to fully
remove (Figure 27).
Figure 27: Flush Island Trim Rear Screw Removal
Installation Instructions
3. Align the back panel of the new accessory with the
flanges on the range side panels right and left rear
corners. The backguard is inserted inside the guide
channels on the back of the range (Figure 28).
4. Make sure the backguard's front face is outside the
flange on the front side of the range.
5. Reinstall screws removed in Steps 1 and 2.
Figure 28: Backguard Installation
Figure 29: Backguard Installation
English 23