Thermador PROFESSIONAL PRO GRAND PRD364JDGC Instructions D'installation page 15

Masquer les pouces Voir aussi pour PROFESSIONAL PRO GRAND PRD364JDGC:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

To Reinstall the Oven Door
1. Hold the door firmly in both
2. Hold the door at a 30° angle
3. Open door fully to expose
4. Flip the hinge forward and
5. Close and open the door
To Check Door Fit and Adjustment
1. Open and close the door slowly to test the movement
and the fit of the door to the oven cavity. Do not force
the door to open or close. If the door is properly
installed, it should move smoothly and rest straight on
the front of the range when closed.
2. The range must be level for proper alignment of the
oven doors, see "STEP 9: Placing and Leveling the
Range".
3. If the door does not operate correctly, verify that the
hinges are properly seated into the hinge slots, and
that the hinge clips are fully engaged into the slots.
4. If door or handle appears slightly tilted, you may adjust
the hinge receiver by rotating the large Torx-head
screw located directly above the hinge receiver with a
T-20 Torx driver. Rotate each screw respective to its
side and direction the door needs to be adjusted
(Figure 12).
Installation Instructions
hands.
from the closed position.
Insert hinges centered evenly
into the hinge slots. The
hinges will securely hook into
the slots when properly
installed. DO NOT force,
bend or twist the door.
hinges, levers, and slots.
down until seated on the
bracket. A screwdriver may
be required to carefully push
the clip back.
slowly to ensure it is correctly
and securely in place.
Figure 11: Door Install
Figure 12: Hinge Receiver Adjustment Screw
NOTE: The steam oven door is not adjustable.
Adjustment for the Warming Drawer Front
1. To align the warming drawer to the steam oven door,
loosen the (2) Torx screws on both sides of the drawer
frame to adjust the tilt. Tighten the screws.
2. To align the gap between the doors, loosen the (4)
Torx screws on the back side of the warming drawer
door. Adjust the vertical and horizontal direction until
the oven door edges are aligned. Tighten the screws.
2
Figure 13: Warming Drawer Adjustment
1
English 14

Publicité

Table des Matières
loading

Table des Matières