Step 3: Unpacking, Moving And Placing The Range - Thermador PD30 Instructions D'installation

Step 3: Unpacking, Moving and Placing The Range

CAUTION
Proper equipment and ad-
equate manpower must be
used in moving the range
to avoid injury, and to avoid
damage to the unit or the
floor. The unit is heavy
and should be handled
accordingly.
• The range has an approximate
shipping weight as shown in
Chart A. The grates, griddle plate
and frame, burner caps, front
kick panel and oven racks must
be removed to facilitate han-
dling. This will reduce the weight
as shown in Chart A and allow
the range to pass through 30"
doorways. See Figs. 2A and 2B
on Page 5. Do not remove the
grill or griddle assemblies.
• Remove the outer carton and
packing material from the ship-
ping base. The dual fuel ranges
are held to the skid by four (4)
bolts (see Fig. 4 and 5). After
removing the bolts the range
must be lifted and removed from
the skid.
• Remove angle-mounting brack-
ets from range. This requires
the installer to remove two
screws holding each bracket
then remove bracket and rein-
stall screws.
NOTE: Leave adhesive-backed
foam layer over brushed-metal sur-
faces, to protect finish from
scratches, until the range is in-
stalled in final position.
Chart A
Shipping Weight
Weight without
packing materials
Without door(s),
burner caps, front kick
panel and oven racks
FIG. 4 – Removal of Two
Front Shipping Bolts
IMPORTANT: Do not lift the
range by the oven door's
handle, as this may damage the
door hinges and cause the door
to fit incorrectly to the oven
cavity.
8
30" Range 36" Range
335 lbs. 444 lbs.
285 lbs. 390 lbs.
215 lbs. 295 lbs.
FIG. 5 – Removal of Two
Rear Shipping Bolts
Left Rear
Shipping
Bolt
48" Range
584 lbs.
524 lbs.
395 lbs.