Step 7: Backguard Installation - Thermador PD30 Instructions D'installation

The backguard must be attached before sliding the
range into the final installed position. A Low Back or
Pot and Pan Shelf must be installed when there is less
than a 12" clearance between combustibles and the
back of the range above the cooking surface. (See
Fig. 2A and 2B on Page 5).
An Island Trim is available for covering the backguard
mounting flanges for island installations, where there
is a minimum of 12" of horizontal clearance behind the
island trim. (See Fig. 2B on Page 5).
The backguard is inserted, as shown in Fig. 13, into
the guide channels on the back of the range. Secure
the backguard with the (4) sheet metal screws pro-
vided.
WARNING
To avoid possible burn or fire hazard, a
backguard designed specifically for this
range must be installed whenever the
range is used.
CAUTION
The Pot and Pan Shelf can get very hot!
DO NOT place the following items on top
of the Pot and Pan Shelf:
- plastics or containers that can melt
- flammable items
- a total load over 30 pounds (13.6kg)
Chart C: BACKGUARD KIT MODEL NUMBERS
MODEL
30"
36"
48"

Step 7: Backguard Installation

:
9" STD. LOW BACK
Included
N/A
N/A
FIG. 13
Front of Unit
12" LOW BACK 22" POT AND PAN SHELF
N/A HS30R
LB36R HS36R
LB48R HS48R
16
Backguard
Installed
-3
3 / " ISLAND TRIM
4
IT30R
IT36R
IT48R