Publicité
Integra-D Troubleshooting Guide
CAUTION: Always disconnect power cord before servicing.
WARNING: Repairs should only be performed by an authorized service center.
1. Machine is not plugged
2. Socket breaker has been tripped
3. Motor breaker has been tripped
4. Faulty receptacle
5. Defective switch / wiring
1. Faulty receptacle
2. Faulty extension cord
3. Defective switch
4. Defective motor
1. Excessive weight for application
2. Faulty Breaker
3. Extension cord too long
4. Bearing seizing
1. Worn pad
2. Worn isolators
1. Isolators worn
2. Component has come loose
1. Isolators worn
Machine won't start
CAUSE
Runs unpredictably
CAUSE
Fuse / Breaker Trips
CAUSE
Machine pulls hard to the right
CAUSE
Machine is unusually loud
CAUSE
Burning/Melting smell
CAUSE
PROBLEM:
1. Check wall outlet and motor connection
2. Reactivate breaker
3. Press manual reset on motor box
4. Move to new receptacle
5. Contact Dustbane dealer
PROBLEM:
1. Move to new receptacle
2. Use new 10 gauge extension cord less than 25 feet
3. Contact Dustbane dealer
4. Contact Dustbane dealer
PROBLEM:
1. Reduce machine weight
2. Breakers in electrical panel need replacement by electrician
3. Move machine to new receptacle closer to worksite
4. Replace bearing assembly or contact dealer
PROBLEM:
1. Replace pad
2. Replace isolators
PROBLEM:
1. Replace isolators
2. Tighten all screws, bolts, knobs
3. Replace foam pads where weights sit
PROBLEM:
1. Replace isolators
Parts & Operations Manual
SOLUTION
SOLUTION
SOLUTION
SOLUTION
SOLUTION
SOLUTION
Integra-D
7
Publicité
