Publicité
Liability statement
This Dustbane product has been built to the highest industry standards. Please note and heed the WARNING and CAUTION labels
that have been placed on the equipment and in this manual for your safety. PLEASE DO NOT ATTEMPT TO OPERATE OR REPAIR
THIS EQUIPMENT WITHOUT ADEQUATE TRAINING. ANY USE, OPERATION OR REPAIR IN CONTRAVENTION OF THIS DOCUMENT IS AT
YOUR OWN RISK. BY ACCEPTANCE OF THIS SYSTEM YOU HEREBY ASSUME ALL LIABILITY CONSEQUENT TO YOUR USE OR MISUSE
OF THIS EQUIPMENT. DUSTBANE SHALL NOT BE LIABLE FOR ANY INCIDENTAL, INDIRECT, SPECIAL OR CONSEQUENTIAL DAMAGE
OF ANY KIND.
Equipment specifications, applications and options are subject to change at the sole discretion of Dustbane without notice.
Safety
Dustbane products are built to strict safety and reliability specifications in accordance with industry standards. Therefore, safety
issues pertaining to operation and repair of Integra-D equipment are primarily environmental and human interface. The following
basic safety tips are given to ensure safe installation, operation and maintenance of the Integra-D.
Transport of Machine
CAUTION: This machine is very heavy. Please disassemble machine prior to transportation off site. Get assistance when lifting the base
assembly. Do not attempt to lift alone.
To transport this machine, the following procedure is advised:
• Unplug machine from power source.
• Unplug the motor from the handle.
• Leave the buffer pad attached to the face grip as to not prematurely wear the machine.
• Wrap cord using cord wrap and handle.
• Unscrew the weight locking knobs and slide the weights out.
• Unlock the locking cam by raising the handle to the vertical position.
• Remove the two safety pins.
• Remove the handle from the handle support and place aside.
• The axle may be used as a carry handle.
• The handle, base assembly and weights may be transported separately.
General Operating Instructions
1.
Move machine to work location. Never operate, transport, or store the machine without a pad to protect the grip face.
2.
Plug machine into grounded power outlet.
3.
Stand behind the Integra-D and place your hands on the padded handle grips.
4.
Push the safety lever away from you with your thumbs and squeeze the trigger with remaining finger. The machine
naturally and gently rotates in a clockwise motion if left unmanaged. Please use both hands to operate the machine.
5.
If equipped with a Fast Track Vacuum, turn the vacuum switch on once the base is running if it's not already on.
It is recommended to leave the Vacuum running at all times since the vacuum air flow helps with cooling reducing
the frequency of maintenance.
6.
Begin moving forward in straight lines.
7.
Best results are found when the handle is used in an upright position. However the handle may be tilted to suit your
application. Open the quick release cam handle and slide the pin into the desired stop. Always use the machine with
the pin firmly in a stop. Firmly close the cam with your hand. The cam lever must not be rotated to achieve tightness.
Instead open and close the lever. A tightness adjustment may be made on the locking nut opposite to the lever.
8.
Continue moving in straight lines, checking your pad every 15 to 30 minutes (depending on pad in use) to maintain
optimum performance.
Parts & Operations Manual
5
Integra-D
Publicité
