EUROM DryBest 30 Wifi Manuel D'utilisation page 24

Please note: in case, the water tank has not been positioned well, the water full
indicator keeps burning. The equipment does not work
Please note: Do not remove the float from the reservoir.
No full reservoir signal will then be given and water will be
able to leak out of the tank.
8. [UP & DOWN] buttons
You can use the UP and DOWN buttons to set the desired air humidity, from 30% to
90% (intervals of 5%). Both displays will show the set air humidity for a few
seconds and then the current air humidity. Once the set level has been reached
(+/- 2%), the compressor will stop; the fan continues to run. The dehumidifier thus
keeps the air in the room moving and is therefore able to feel the humidity and to
catch on again in time. If the air humidity rises to 3% over the set value, the device
will restart. Between stopping and then restarting, the compressor will always apply
a protection time of 3 minutes.
If you set the air humidity using the UP and DOWN buttons to 'CO', the device will
carry on working irrespective of the air humidity level in the room. If you set the air
humidity using the UP and DOWN buttons to 'AU', the device will constantly
maintain air humidity at a comfortable level. That being:
Room temperature < 5 °C:
Room temperature between 5 and 20 °C:
Room temperature between 20 and 27 °C:
Room temperature < 27 °C:
9. [C° en %] indicator lights
If both the UP and DOWN buttons are pressed simultaneously, both displays change
from showing the air humidity percentage to the temperature and then back again.
The corresponding indicator lights % or C light up.
10. [MODE] button. (The corresponding lights will go on)
 DEH: Dehumidifier setting
Device stops working
60% air humidity
55% air humidity
50% air humidity
24