Troubleshooting - Scheppach AIR FORCE 2 Traduction Des Instructions D'origine

13. Troubleshooting

Fault
The compressor does not start.
The compressor starts but there
is no pressure.
The compressor starts, pressure
is shown on the pressure gauge,
but the tools do not start.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Possible cause
No supply voltage.
Insufficient supply voltage.
Outside temperature is too low.
Motor is overheated.
The non-return valve leaks.
The seals are damaged.
The hose connections have a leak.
A quick-lock coupling has a leak.
Remedy
No supply voltage.
Insufficient supply voltage.
Outside temperature is too low.
Motor is overheated.
The non-return valve leaks.
The seals are damaged.
The hose connections have a leak.
A quick-lock coupling has a leak.
GB | 25