Scheppach HC 52dc Traduction Du Manuel D'origine page 17

sor. Only then cut the mains supply or pull the power
supply plug.
• Before working with the compressor, check the oil level.
It must be near the red circle as shown on the display.
Attention: Oil must be filled in before the initial put-
ting into operation.
• After using the compressor, press the ON/OFF switch,
cut off the mains supply, and open the drain valve in
order to reduce the pressure.
• Do not try to remove a part from the machine while it
is pressurized.
• Make sure the lubrication oil is clean and always avail-
able in sufficient quantity. Change the oil according to
the instructions given in the chapter „Maintenance"
of this manual.
• Wear safety gears including goggles or a screen, ear pro-
tection, breathing mask and protective clothing.
• After connection to the mains and switching on, the
machine starts automatically.
• Air escaping from the compressor may not be inhaled.
• Check the pressure control valve daily before starting
work.
• Drain humidity from the tank. Avoid tank corrosion.
• Cut off the mains supply, remove the power supply
plug, and relieve the pressure before starting mainte-
nance work.
Wear goggles.
Wear ear protection.
Wear a breathing mask.
Never direct the output air from the compressor towards
a part of the body or a person. Never try to block the air
escape with your finger or a part of your body.
m use as authorized
The machine meets all valid EC machine guidelines.
• The machine must only be used in technically perfect
condition and conscious of the risks, in accordance
with its designated use and the instructions set out in
the operating manual.
• Any functional disorders, especially those affecting the
safety of the machine, must be rectified immediately.
• The safety, working and maintenance instructions of
the manufacturer as well as the dimensions given in the
chapter „Technical data" must be adhered to.
• The relevant accident prevention regulations and other,
generally recognized safety-technical rules must also
be adhered to.
BA HC 52dc.indd 17
international 17
09.02.12 11:04