Using Sleep Timer - JVC FS-J60 Manuel D'instructions

5
Press UP or DOWN to set the volume level,
then press CLOCK/TIMER.
• You can select the volume level ("VOLUME – –" and
"VOLUME 0" to "VOLUME 40").
If you select "VOLUME – –," the volume is set to the
previous level when the unit was turned off.
• To turn off the volume while the Recording Timer
( REC TUNER) is working, set the volume level
"VOLUME 0."
The unit enters the clock setting mode.
6
Adjust the clock if you need.
• See "Setting the Clock" on page 9.
7
Press STANDBY/ON
off the unit (standby) if you have
set the timer with the unit turned
on.
• When the timer turns on the unit, the
the selected timer mode indicators (DAILY or REC)
start flashing.
To deactivate the timer temporarily, press
and hold CLOCK/TIMER until the
indicator on the display goes off.
To activate or change the timer (with the previous
setting), follow steps 1 to 7 on pages 20 and 21.
• If you want to change the timer setting after the Daily
Timer be used, first deactivate the timer.
• If the unit is turned on when the timer on-time comes
Timer does not work.
• When you unplug the AC power cord or if a power failure
occurs
The timer will be canceled. You need to set the clock first, then
the timer again.
21

Using Sleep Timer

With the Sleep Timer, you can fall asleep to music. You can
set the Sleep Timer when the unit is turned on.
How the Sleep Timer actually works
The unit automatically turns off after the specified time
length passes.
On the remote control ONLY:
1
to turn
STANDBY/ON
(timer) and
2
CLOCK
/TIMER
(timer)
To check the remaining time until the shut-off time, press
SLEEP once so that the remaining time until the shut-off time
appears for about 5 seconds.
• The illumination and display brighten during this period.
To change the shut-off time, press SLEEP repeatedly until
the desired time length appears on the display.
To cancel the setting, press SLEEP repeatedly until the
SLEEP indicator goes off.
• The Sleep Timer is also canceled when you turn off the
• If you set the Sleep Timer after the Daily Timer starts playing
• If you set the Sleep Timer after the Recording Timer starts
Press SLEEP.
The time length until the shut-off time appears
and the SLEEP indicator lights up on the
display.
• Each time you press the button, the time length
changes as follows:
SLEEP 10 SLEEP 20
Canceled SLEEP120
Wait for about 5 seconds after specifying
the time length.
The illumination and display dim.
unit.
the selected source
The Daily Timer is canceled. When the Sleep Timer shut-off time
comes, the unit will be turned off.
recording
The Recording Timer is canceled, but recording continues until
the Sleep Timer shuts off the power.
SLEEP
SLEEP 30
SLEEP 60
SLEEP 90