Requirements For Product Use - Festo EGSL Notice D'utilisation

EGSL
4

Requirements for product use

Warning
Unexpectedly fast moveable masses can harm people or property (crushing).
• Apply power to the drive motor, at first limited to low speeds and torques.
Note
Particles (e.g. dust, liquids, ...) which penetrate the mechanics of the EGSL can
cause damage or lead to reduced performance.
• Make sure that the dust concentrations for the permitted IP protection class
are complied with (è chapter 12 "Technical data").
The cover (è Accessories) prevents reaching between guide rail and end
cover, but not penetration of dust and contamination.
Note
Malfunctions will occur if the device is not used correctly.
• Be sure to always comply with the specifications in this chapter. In this way,
the product will perform as intended.
• Compare the limit values specified in these operating instructions with those
of your actual application (e.g. forces, torques, temperatures, masses, speeds).
Only compliance with the load limits allows operation of the product in
compliance with the relevant safety regulations.
• Take into consideration the ambient conditions at the location of use.
Corrosive elements in the environment (e.g. ozone) will reduce the service life of
the product.
• Comply with the regulations of the trade association, the German Technical
Control Board (TÜV) or corresponding national regulations.
• Remove transport packaging such as films and cardboard.
The packaging is intended to be recycled on the basis of its constituent
materials (exception: oiled paper = other waste).
• Use the product in its original condition without any unauthorised
modifications.
22
Festo EGSL 1602b English