Requirements For Product Use - Festo SLTE Notice D'utilisation

SLTE
5

Requirements for product use

Note
Dust particles in the drive rod bearing can, under circumstances, cause the
drive rod to jam.
S Make sure that the maximum concentration of dust for complying with the
permitted IP protection class is not exceeded (see Technical Specifications).
Note
The SLTE may be damaged if the slide is moved manually and strikes the end
position at an excessively high speed.
S Make sure that the max. permitted speed is not exceeded when the slide is
pushed manually (see Technical Specifications).
The SLTE may be damaged if it strikes the end position at an excessively high
speed.
Note
Improper handling can result in malfunctions.
S Be sure to always comply with the specifications in this chapter.
This is the only way to ensure correct and safe product behaviour.
Compare the maximum values specified in these operating instructions with
S
those of your actual application (e.g. forces, torques, temperatures, masses,
speeds).
The SLTE can only be operated in accordance with the relevant safety guide
lines if the maximum loading limits are observed.
Take into consideration the ambient conditions at the location of use.
S
Corrosive environments reduce the service life of the SLTE.
Please comply with national and local safety laws and regulations.
S
Remove transport packaging such as foils, caps and cardboard.
S
The packing is intended for recycling (except for: oiled paper = other waste).
Festo SLTE 0910a English
27