Conditions For The Safe Use Of The Product - Festo DNCE LAS Série Notice D'utilisation

DNCE−...−LAS
4

Conditions for the safe use of the product

Warning
Hot surface temperatures (up to 70 °C in normal operation, over 100 °C when
there is a fault) can cause burns or cause inflammable materials to ignite.
S Make sure that hot surfaces on the electric cylinder:
are either inaccessible (e. g. by means of a protective grill) or
can be touched only with adequate protection to prevent burning
(e.g. provision of protective gloves)
are not situated in the vicinity of inflammable materials
(e.g. inflammable cleaning agents).
Warning
Strong magnetic fields impair the functioning of electronic devices
(e.g. heart pacemakers). Magnetic forces can lead to dangers (injuries).
S Always leave the linear motor 4 fitted inside the DNCE−LAS. Otherwise
strong magnetic fields may occur. When the device is fitted the magnetic
fields present no problems.
S Do not modify the settings of screws and threaded pins if there is no request
to do this in these operating instructions.
S Note that magnetic fields can also occur if the linear motor is badly damaged
(e. g. due to incorrect transport).
Warning
High speeds during initial commissioning can lead to critical movement
sequences.
S Carry out the initial commissioning of the drive system with reference travel
and low speeds, masses and forces.
Low speeds are specified with the reference travel.
Note
Particles (e. g. dust, liquids, ...) which penetrate the mechanics of the electric
cylinder can cause damage or lead to reduced performance.
S Make sure that the dust concentrations for the permitted IP protection class
are complied with (è chapter 12 Technical Specifications").
26
Festo DNCE−...−LAS 1003b English