Festo EGSL Notice D'utilisation page 25

EGSL
Installing the effective load
Note
If the steel slide becomes bent against a
buckled effective load, the service life of the
guide will be reduced.
• Make sure that the mounting surface of
the effective load is even to within
t ≤ 0.05 mm.
• Place the effective load so that the pull-out torque from the force
(parallel to the axis of motion) and lever arm remains low.
• Check the necessity of adapter plates.
Connection of the EGSL to
Festo handling components is made
possible through adapter plates
(è chapter 10 "Accessories").
• Fasten the effective load to the slide
unit with screws (A) and, if necessary,
with centring elements (B).
The screw-in depth must be less
than the threaded holes.
EGSL-...
Screw
Centring sleeve
Min. screw-in depth
– Guide rail
– Yoke plate
Festo EGSL 1602b English
35
(A) M4
(B) [mm] 7x3
(ZBH-7)
[mm] 3.6
[mm] 4.8
Fig. 5
(A)
(B)
Fig. 6
45 55
M5 M5
7x3 7x3
(ZBH-7) (ZBH-7)
4.5 4.5
6 6
75
M6
9x4
(ZBH-9)
5.4
7.2
25