Kenwood KWL90 Mode D'emploi page 8

Only use the appliance for its intended domestic
use. Kenwood will not accept any liability if the
appliance is subject to improper use, or failure to
comply with these instructions.
This appliance is not intended to be operated by
means of an external timer or separate remote-
control system.
Before plugging in
Make sure your electricity supply is the same as the one shown on the underside of your
appliance.
WARNING: THIS APPLIANCE MUST BE EARTHED.
This appliance conforms to EC Regulation 1935/2004 on materials and articles intended
to come into contact with food.
Before Using For The First Time
Wash the parts: see 'Care and
Cleaning' section.
Key
Attachment outlets
High-speed outlet
1
Slow-speed outlet
2
Bowl tool socket
3
Mixer
High speed outlet cover
4
Mixer head
5
Head release lever
6
On/Off switch
7
Display screen
8
Control Dial
9
Power unit
10
a 7L Warming Bowl
11
b 5L Bowl
11
In-bowl illumination 'Bowl Bright™'
12
Slow speed outlet cover
13
Temperature sensor
14
Warming plate
15
Air vent
16
K-beater
17
Creaming beater
18
Whisk
19
Dough tool
20
Spatula
21
Head shield
22
Splashguard
23
Feed chute lid
24
Note: Spanner shown is for illustration
purposes only and is not supplied in
pack.
Optional Attachments
There are a range of optional
attachments available to use with
your Stand Mixer. See the attachment
leaflet included in your pack or visit
www.kenwoodworld.com to see the full
range and how to buy an attachment
not included in your pack.
Note: Slow Speed Outlet Attachments
The slow speed outlet on your Stand
Mixer model features the Twist
Connection System. It is designed
to accept Twist Connection System
attachments.
When purchasing new attachments for
the slow speed outlet you should check
compatibility with your Stand Mixer. All
Twist Connection System attachments
can be identified by the product code
which starts with KAX and also by
the Twist logo
packaging. For more information visit
www.kenwoodworld.com/twist.
If you own attachments featuring the
Bar Connection System
need to use the KAT002ME adaptor to
connect these to the Twist Connection
System on your Stand Mixer.
For more information visit
www.kenwoodworld.com/twist.
4
which is visible on
you will