Bosch Benchmark Serie Mode D'emploi page 34

Oven Problem
Oven light does not turn off.
Cannot remove lens cover on light.
Oven is not self-cleaning properly.
Clock and timer are not working
properly.
"E" and a number appears in display
and control beeps.
With a new oven there is a strong
odor when oven is turned on.
Control does not react when a key is
touched.
Warm air or steam escapes from oven
vent.
Cooling fan runs even when the oven
is turned off.
English 31
Possible Causes and Suggested Solutions
Check for obstruction in oven door. Check to see if hinge is bent.
There may be soil build-up around the lens cover. Wipe lens cover area with a
clean, dry towel prior to attempting to remove the lens cover.
Allow the oven to cool before running Self Clean. Always wipe out loose soils
or heavy spillovers before running Self Clean. If oven is badly soiled, set oven
for the maximum Self Clean time.
Make sure there is electrical power to oven.
This is a fault code. Press any key to stop beeping. Reset oven if necessary. If
fault code remains, record fault code, cancel oven, and call authorized service
technician.
This is normal with a new oven and will disappear after a few uses. Operating
the Self Clean cycle also "burns-off" the smell more quickly.
Be sure that surface is clean and dry. Touch the center of the button. Use the
flat part of your finger.
It is normal to see or feel steam or warm air escaping from the oven vent. Do
not block the vent.
This is normal. The cooling fan will continue to run, even after the oven has
been turned off, until the oven has cooled sufficiently.