Troubleshooting - Emerson LURAY ECO CF860B000 Mode D'emploi

FOR YOUR OWN SAFETY TURN OFF POWER AT FUSE BOX OR CIRCUIT BREAKER BEFORE
TROUBLESHOOTING YOUR FAN.
TROUBLE
1. Fan will not start.
1. Loose electrical connections in the
ceiling cover.
2. Fan sounds noisy. 1. Blades not attached to fan.
2. Wire connectors inside light kit assembly
are rattling.
3. Screws holding blades to motor are
loose.
3. Fan wobbles
excessively.
1. Setscrews in motor coupler are loose.
2. Setscrew in hanger ball/downrod
assembly is loose.
3. Screws securing fan blades to
motor are loose.
4. Hanger bracket and/or ceiling outlet
box is not securely fastened.
INSTRUCTION TO THE USER (if device contains a digital device)
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This equipment has been certified to comply with the limits for a class B computing device, pursuant to FCC Rules.
In order to maintain compliance with FCC regulations, shielded cables must be used with this equipment. Operation
with non-approved equipment or unshielded cables is likely to result in interference to radio and TV reception. The
user is cautioned that changes and modifications made to the equipment without the approval of manufacturer
could void the user's authority to operate this equipment.
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.

17. Troubleshooting

!
PROBABLE CAUSE
WARNING
1. Check the electrical connections at the ceiling cover.
Make sure main power is turned OFF.
1. Attach blades to fan before operating.
2. Check to make sure wire connectors in light kit assembly
are not rattling against each other or against the interior
wall of the light kit assembly.
Make sure main power is turned OFF.
3. Tighten screws securely.
1. Tighten both setscrews securely in the motor coupler.
2. Tighten the setscrew in the hanger ball/downrod
assembly.
3. Check to be sure screws which attach the fan blades
to the motor are tight.
4. Tighten the hanger bracket screws to the outlet box,
and/or secure outlet box.
34
SUGGESTED REMEDY
WARNING
!
WARNING
!