Light Kit Led Array Assembly Replacement - Emerson LURAY ECO CF860B000 Mode D'emploi

14. Light Kit LED Array Assembly Replacement

WARNING
!
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
Tools Needed
One Phillips head screwdriver
One stepladder
14.2
Rotate and remove the shade counter-clockwise to
expose the Light Kit Assembly (Figure 38).
Retain shade for future reinstallation.
14.3
Loosened the two Light Kit Adapter #6-32 x .375" pan
head screws located in the key hole slots.
Remove the remaining Light Kit Adapter #6-32 x .375"
pan head screw (Figure 39). Retain for future use.
Rotate the Light Kit Assembly counter-clockwise to
disengage the two screw heads in the key hole slots for
removal of Light Kit Assembly.
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring must
be in accordance with National and Local codes and
the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
14.1
Disconnect electrical power to the branch circuit at the
circuit breaker or fuse box before attempting to install
the ceiling fan mounting plate on the outlet box.
ROTATE COUNTER-
CLOCKWISE
Figure 38
LOOSEN L IGHT KIT ADAPTER
PAN HEAD SCREW S (2)
ROTATE COUNTER-
L IGHT KIT ADAPTER PAN
Figure 39
HEAD SCREW (1)
26
WARNING
LIGHT KIT
ADAPTER
RAISED
DIMPLES (3)
SHADE
FLAT AREA OF
SHADE (3)
L IGHT KIT
ASSEMBLY
CLOCKWISE