Programming The Receiver Operating Frequency & High Speed Conditioning Of Fan Control - Emerson LURAY ECO CF860B000 Mode D'emploi

9. Programming the Receiver Operating Frequency
& High Speed Conditioning of Fan Control
-- Important - Read This Section Carefully and Follow
the High Speed Conditioning Instructions Closely --
PROGRAMMING THE RECEIVER
OPERATING FREQUENCY & HIGH SPEED
CONDITIONING OF FAN CONTROL
IMPORTANT: Ceiling fan blades MUST be installed
before high speed conditioning can begin.
NOTE: If using a 3-way switch installation, ensure
that both wall controls are using the same switch
code.
9.1
Turn the wall switch ON/OFF switch to the "OFF"
position.
Restore electricity to the ceiling fan branch circuit at the
circuit breaker or fuse box
Flip the wall control's ON/OFF switch to "ON" position.
Within one minute of flipping the switch to "ON", push
and hold the FAN OFF button (
set the code in the receiver. The ceiling fan lights
(if installed) will blink to indicate the wall control code
IMPORTANT: Immediately after successful pairing,
has been paired with the receiver.
the ceiling fan will automatically begin high speed
conditioning of the motor. During conditioning, the
electronic motor control software is calculating
speeds for the 2nd through 5th speed settings
based on the blades that were installed on the fan.
The fan will run for approximately 1 minute in the
upward direction then reverse direction to down flow
and run an additional 1 minute. When conditioning is
IMPORTANT: Do not interrupt the conditioning until
complete, the fan will come to complete stop.
the fan comes to a complete stop in approximately
3 minutes. All functions of the control will be
rejected during conditioning.
High speed conditioning is now complete.
) for 3 to 5 seconds to
23
9.2
If programming is unsuccessful, retry the previous
instructions after cycling the wall control ON/OFF switch
to restart the 1 minute programming time period.
If still unsuccessful, shut off the electricity at the fuse
box or breaker panel and change the wall control
frequency (Section 8.3, Page 18).
After changing the frequency settings, repeat
instructions in Section 9.1 within one minute of restoring
the electricity.