Programming The Receiver Operating Frequency - Emerson IDEAL Mode D'emploi

8. Programming the Receiver Operating Frequency

-- Important - Read This Section Carefully --
IMPORTANT: Ceiling fan blades MUST be installed
before programming can begin.
NOTE: If using a 3-way switch installation, ensure
that both wall controls are using the same switch
code.
8.1
Turn the Wall Switch ON/OFF Switch to the "OFF"
position.
Restore electricity to the Ceiling Fan Branch Circuit at
the Circuit Breaker or Fuse Box.
Flip the Wall Control's ON/OFF Switch to "ON" position.
Within one minute of flipping the switch to "ON", push
and hold the FAN OFF button (
set the code in the receiver. The ceiling fan lights
(if installed) will blink to indicate the wall control code
has been paired with the receiver.
) for 3 to 5 seconds to
21
8.2
If programming is unsuccessful, retry the previous
instructions after cycling the wall control ON/OFF switch
to restart the 1 minute programming time period.
If still unsuccessful, shut off the electricity at the fuse
box or breaker panel and change the wall control
frequency (Section 7.3, Page 16).
After changing the frequency settings, repeat
instructions in Section 8.1 within one minute of restoring
the electricity.
Please contact 1-800-654-3545 for further assistance
emersonfans.com
ETL Model No.: CF330