Emerson IDEAL Mode D'emploi page 7

3. Ceiling Fan Assembly
3.5
Remove the Hanger Ball by loosening the Phillips Head
Set Screw in the Hanger Ball until the Ball falls freely
down the 4.5" Downrod (Figure 5).
Remove the Pin from the 4.5" Downrod, then remove the
Hanger Ball (Figure 5).
Retain the Pin and Hanger Ball for reinstallation in
Step 3.11.
Note: Do not loosen the screw that attaches the
green ground wire to the hanger ball.
3.6
Separate, untwist and unkink the two 80" Motor Wires.
Route the two Motor Wires through the 4.5" Downrod
(Figure 6).
3.7
Loosen the two Phillips Head Set Screws in the Motor
Coupler for installation of the Downrod (Figure 7).
Seat the Downrod in the Motor Coupler (Figure 7).
Rotate and align the Downrod holes with all the holes in
the Motor Coupler (Figure 7).
(Continued)
PIN
PHILLIPS HEAD SET SCREW
(LOOSENED)
Figure 5
TWO 80" MOTOR WIRES (UNTWISTED)
Figure 6
LOOSEN
PHILLIPS HEAD
SET SCREWS (2)
Figure 7
7
GREEN GROUND WIRE
4.5" DOWNROD
HANGER BALL
4.5" DOWNROD
4.5"
DOWNROD
MOTOR
COUPLER
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF330