Ceiling Fan Assembly - Emerson IDEAL Mode D'emploi

3.1
Flip the upper foam pad over and place on a stable
working surface.
Remove the fan motor assembly from the protective
plastic bag.
Place fan motor assembly on top of the foam pad with
the upper motor cover supporting the weight of the
motor.
Remove and discard the three Shipping Retainers
securing the Motor Hub in the Motor Housing (Figure 1).
This will permit access for the blades to be installed.
3.2
Place the Fan Blade onto the Blade Flange, as shown.
NOTE: The blade must be installed with the blade
markings "THIS SIDE UP" facing up.
Mount the Fan Blade onto the Blade Flange using three
#8-32 x 1/4" Washer Head Screws (supplied) (Figure 2).
Repeat for all three blade/flange sets.

3. Ceiling Fan Assembly

MOTOR HUB
Figure 1
Figure 2
5
SHIPPING
RETAINERS (3)
MOTOR HOUSING
#8-32 x 1/4" WASHER HEAD
SCREWS (3 per blade)
FAN BLADE (3 per fan)
BLADE
FLANGE
(3 per fan)
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF330