Ceiling Fan Assembly - Emerson CF279BS00 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3.1
Remove the Three Rubber Shipping Spacers and
Screws to free the Motor Hub for installation of the
Ceiling Fan Blade Assemblies, as follows:
Unscrew the Two Shipping Spacer Screws with
Washers from each Rubber Shipping Spacer.
Remove and Discard the Three Rubber Shipping
Spacers, Six Screws and Six Washers (Figure 1).
3.2
Place a Fan Blade onto the Fan Housing Assembly
engaging the 2-studs on the Fan Blade into the two
maller holes of the Fan Housing Flywheel (Figure 2).
NOTE: Be sure to assemble the blades with the
2-studs facing down and connected into the two
smaller holes on the Fan Housing Assembly.
Position a Fan Blade Support Plate flush on the Fan
Blade.
NOTE: If the Fan Blade Support Plate is NOT flush
on the Fan Blade, the Fan Blade is positioned
incorrectly.
Mount the Fan Blade Support Plate and Fan Blade
onto the Fan Housing Assembly using three 1/4-20 x
17 mm Pan Head Screws with Lockwashers (supplied)
(Figure 2).
Repeat for remaining Fan Blade Support Plates and
Fan Blades.
NOTE: Take care not to scratch the Fan Housing
Assembly when installing the Fan Blades.
WARNING
!
To reduce the risk of personal injury, do not bend
the blade flange when installing the blade flanges,
balancing the blades or cleaning the fan. Do not insert
foreign objects in between rotating fan blades.

3. Ceiling Fan Assembly

Figure 1
1/4-20 x 17 mm
PAN HEAD SCREWS
w/LOCKWASHERS
(3 per blade)
FAN BLADE
SUPPORT PLATE
FAN BLADE
STUDS (2)
FAN HOUSING
FLYWHEEL
Figure 2
5
RUBBER SHIPPING
SPACERS (3)
SHIPPING SPACER
SCREWS (2 per spacer)
SHIPPING
WASHERS
(2 per spacer)
MOTOR
HUB
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF279

Publicité

Table des Matières
loading

Table des Matières