Emerson CF279BS00 Mode D'emploi page 17

6.4
Screw the Two Threaded Studs (supplied) into the
Tapped Holes in the Hanger Bracket (Figure 30).
NOTE: Be sure the wires stay on the outside of the
threaded rods when installing the ceiling cover.
6.5
Lift the Ceiling Cover up to the Threaded Studs and
turn until studs protrude through the holes in the Ceiling
Cover (Figure 31).
Secure the Ceiling Cover in place by sliding
Lockwashers (supplied) over the Threaded Studs and
installing the two Knurled Knobs (supplied). (Figure 31).
Tighten the Knurled Knobs securely until the Ceiling
Cover fits snugly against the ceiling and the hole in the
Ceiling Cover is clear of the Downrod.
WARNING
!
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the outlet box and
not pinched between the ceiling cover and the ceiling.
You have now completed the assembly of your new
Ceiling Fan.
Please call Technical Support at 1-800-654-3545
if you have any questions about installation and
operation of this Ceiling Fan.
6. Final Assembly
(Continued)
HANGER
BRACKET
HOLES (2)
THREADED
STUDS (2)
Figure 30
Figure 31
17
CEILING
COVER
THREADED
STUDS (2)
LOCKWASHERS (2)
KNURLED
KNOBS (2)
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF279