Emerson IDEAL Mode D'emploi page 15

6.4
Screw the two Threaded Studs (supplied) into the
tapped holes in the Hanger Bracket (Figure 23).
6.5
Lift the Ceiling Cover up to the Threaded Studs and
turn until studs protrude through the holes in the Ceiling
Cover (Figure 24).
Secure the Ceiling Cover in place by sliding
Lockwashers (supplied) over the Threaded Studs and
installing the two Knurled Knobs (supplied). (Figure 24).
Tighten the Knurled Knobs securely until the Ceiling
Cover fits snugly against the ceiling and the hole in the
Ceiling Cover is clear of the downrod.
WARNING
!
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the outlet box and
not pinched between the ceiling cover and the ceiling.
You have now completed the complete assembly of
your new ceiling fan.
Please call Emerson
1-800-654-3545 if you have any questions
about installation and operation of this ceiling fan.
6. Final Assembly
technical support
(Continued)
HANGER
BRACKET
HOLES (2)
THREADED
STUDS (2)
Figure 23
Figure 24
at
15
CEILING
COVER
THREADED
STUDS (2)
LOCKWASHERS (2)
KNURLED
KNOBS (2)
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF330