Emerson LURAY ECO CF860B000 Mode D'emploi page 8

3. Ceiling Fan Assembly
3.7
Separate, untwist and unkink the two 80" motor leads.
Route the two motor leads through the 4.5" downrod
(Figure 7).
3.8
Loosen the two Phillips head setscrews in the motor
coupler for installation of the downrod (Figure 8).
Seat the downrod in the motor coupler (Figure 8).
Rotate and align the downrod holes with all the holes in
the motor coupler (Figure 8).
3.9
Align the clevis pin holes in the downrod with the holes
in the motor coupler.
Install the clevis pin and secure with the hairpin clip
(Figure 9).
The clevis pin must go through the holes in the motor
coupler. It is critical that the clevis pin in the motor
coupler is properly installed and securely tightened.
Evenly retighten the two Phillips head setscrews to
secure the downrod to the motor coupling in a vertical
position (Figure 9).
WARNING
!
It is critical that the clevis pin and setscrews in the motor
coupler are properly installed and securely tightened.
Failure to verify that the pin and setscrews are properly
installed could result in the fan falling.
(Continued)
TWO 80" MOTOR LEADS (UNTWISTED)
Figure 7
LOOSEN
PHILLIPS HEAD
SETSCREWS (2)
Figure 8
HAIRPIN
CLIP
CLEVIS
PIN
CLEVIS
PIN
Figure 9
8
4.5" DOWNROD
4.5"
DOWNROD
MOTOR
COUPLING
MOTOR
COUPLING
HAIRPIN
CLIP