Controls, Indicators And Jumpers Setup; Jumpers And Dip-Switches Setup - GENDEX Oralix AC Manuel De Service

SETTING TO WORK

3. CONTROLS, INDICATORS AND JUMPERS SETUP

For a survay of the controls and indicators of the Timers see CZ-1 and CZ-2.

3.1. JUMPERS AND DIP-SWITCHES SETUP

The table below describes the jumpers and dip-switches setup on Densomat/Secondent Timer.
Factory
default setting
W1 Not used
W2 1-2 (B.U.T. enabled)
W3 Unplugged
W4 Plugged
W5 Closed
W6 Opened
W7 Opened
W8 1-2 (X-ray enabled)
W9 Opened
W10 Closed
W11 Closed (F3 shunted) Opened (F3 working)
S1 DENSOMAT
1 not used
2 OFF=
single Tubehead (*)
ON =
double Tubehead
3 ON= compensation
(**) inhibited (*)
OFF = compensation
enabled
4 OFF= X-ray inhibited
ON = X-ray enabled (*) ON = X-ray enabled (*)
8 not used
(*) = DEFAULT (**) = Manual mode only
(Exposure time selected manually by pressing S+/S- pushbuttons)
Preheating time selection at 50Hz
(applicable for Densomat & Secondent)
TIME S1
(ms) 5 6 7
80 OFF OFF OFF
100 OFF OFF ON
120 (*) OFF ON OFF
140 OFF ON ON
160 ON OFF OFF
180 ON OFF ON
200 ON ON OFF
220 ON ON ON
C-2
DENSOMAT
Custom setting
Not used
2 - 3 (B.U.T. test)
Not used
Not used
Not used
Not used
Not used
2-3 (X-ray inhibited)
Not used
Not used
SECONDENT
see table
"Tubehead version
selection"
OFF= compensation
inhibited
ON =compensation
enabled (*)
OFF= X-ray inhibited
not used
Tubehead version selection
(*)= DEFAULT
Tube version 230V (*)
S1 - 1
S1 - 2 OFF
Printed on: 22 Mär 2012, 09:28:10 am; Printed by: TOBIAS BAUER
Factory
default setting
Not used
1 - 2
Opened
Closed
Closed
Opened
Opened
1-2 (X-ray enabled)
Opened
Closed
Closed (F3 shunted)
(Secondent only )
240V 220V spare
ON OFF ON OFF
ON ON OFF
ORALIX AC SYSTEM
SECONDENT
Custom setting
Not used
Not used
Not used
Not used
Not used
Not used
Not used
2-3 (X-ray inhibited)
Not used
Not used
Opened (F3 working)
Gendex Dental Systems