Samson AirLine AX1 Mode D'emploi page 5

7. Turn on the receiver. The POWER/BATTERY LED will light momentarily indicating the power has been turned on.
8. Turn on your transmitter. The audio signal can be monitored through the 3.5mm stereo headphone output and headphone volume
can be adjusted via the headphone level trim pot with the supplied plastic screwdriver.
9. Turn on your camera or mixer but keep its volume all the way down. If your system contains an AL1 transmitter, make sure it is
unmuted. Set the Volume, Level or AF Level knob on the receiver fully clockwise; this is unity gain.
10. Speak or sing into your mic at a normal performance level while slowly raising the audio input control of your camera (if you
have one) or mixer until the desired level is reached. If necessary, use the supplied plastic screwdriver to adjust the transmitter's
Gain trimpot in order to increase or decrease its signal level. If you are using an AL1 transmitter with the built-in microphone,
correct placement is critical to sound quality. It should be unobstructed by clothing and either clipped to a shirt pocket or lapel,
or worn around the neck on the supplied lanyard.
11. Do a walkaround through the intended area of coverage while monitoring the audio signal via the AM1 receiver headphone out-
put or input level meter (if one is available).
Quick Start
3
Samson AirLine