Samson AirLine AX1 Mode D'emploi page 16

Samson AirLine
• If you are using an AL1 transmitter with its internal electret condenser microphone, simply position the microphone closer to your
mouth. If you are using an AL1 with an external lavalier microphone, use the supplied plastic screwdriver to turn the Gain control
(trimpot) slowly clockwise until the signal reaches an acceptable level.
13. When first setting up your AirLine System in a new environment, it's always a good idea to do a walkaround in order to make sure
that coverage is provided for your entire performance area. Accordingly, turn down the level of your audio system and turn on
both the transmitter and receiver. Then, with the transmitter unmuted, restore the level of your audio system and while speaking or
singing, walk through the entire area that will need to be covered. As you do so, observe the LED on the receiver to make sure
that it is receiving sufficiently strong RF signal (the AM1 receiver "Power On / RF / Low Battery" LED should always remain lit
steadily green). Always try to minimize the distance between transmitter and receiver as much as possible so that the strongest
possible signal is received from all planned transmission points.
If you have followed all the steps above and are experiencing difficulties, contact your local distributor or, if purchased in the United
States, call Samson Technical Support (1-800-372-6766) between 9 AM and 5 PM EST.
Setting up and Using your AirLine System
14