Wiring Diagram - Samson AirLine AX1 Mode D'emploi

When connecting the output of the AM1 to a camera or mixer input, the supplied 2.5mm to 3.5mm SMM14 cable may not accom-
modate your needs. The wiring diagram below depicts common options. The SMM14's 2.5 mm plug can be wired to either a 1/4"
male phone plug or male XLR plug.
note: When connecting the 2.5mm plug to 1/4" phone plug the Tip and Sleeve from the 2.5mm plug are connected to the Tip and
Sleeve of the 1/4" phone plug. The Ring from the 2.5mm plug is not connected. When connecting the 2.5mm plug to an XLR plug,
the Ring from the 2.5mm plug and the cold (solder point number 3) do not make a connection.
Tip (signal)
Tip (signal)
Ring (signal)
Sleeve (ground)

Wiring Diagram

Tip (signal)
Ring (signal)
Ring (no connection)
Sleeve (ground)
Sleeve (ground)
2.5mm to Male Phone
Signal
Ring to Pin 3
(no connection)
Ground
17
Tip (signal)
Sleeve (ground)
Sleeve (ground)
Common (1)
2.5mm to Male XLR
Samson AirLine
Tip (signal)
Hot(2)
Tip
End View
Solder Points
2
1
1 2
3 3
Cold(3)
(Ring to Pin 3
no connection)