Samson AirLine AX1 Mode D'emploi page 15

Setting up and Using your AirLine System
10. Speak or sing into your mic at a normal performance level while slowly raising the volume of your camera and/or mixer until the
desired level is reached. The AM1 receiver allows you to monitor the transmission signal using standard Walkman-type 30 ohm
headphones connected to its headphone jack. Note that Unidirectional microphones (mics which pick up signal from just one
direction) such as the built-in AL1 electret condenser are less prone to feedback than other types of mics. Any feedback problems
you encounter can be minimized by being sure not to use the microphone directly in front of a PA speaker or by using an equal-
izer to attenuate (reduce) those high- or mid-range frequencies which are causing the feedback "squealing".
11. If you hear distortion at the desired volume level make sure that the gain structure of your audio system is correctly set (consult
the owners manual of your mixer and/or camera for details). If distortion persists try the following:
• If you are using an AX1 transmitter, use the supplied plastic screwdriver to turn its Microphone Input Level control (trimpot) slowly
counterclockwise (towards the "Min" position) until the distortion disappears.
• If you are using an AL1 transmitter with its internal electret condenser microphone, simply move the microphone further from
your mouth. If you are using an AL1 with an external lavalier microphone, use the supplied plastic screwdriver to turn the Gain
control (trimpot) slowly counterclockwise until the distortion disappears.
12. Conversely, if you hear a weak, noisy signal at the desired volume level, again make sure that the gain structure of your camera
and/or audio system is correctly set (consult the owners manual of your mixer and/or amplifier for details) If the signal coming
from the receiver is still weak and/or noisy, do the following:
• If you are using an AX1 transmitter, use the supplied plastic screwdriver to turn its Microphone Input Level control (trimpot) slowly
clockwise (towards the "Max" position) until the signal reaches an acceptable level.
13
Samson AirLine