Setting Up And Using Your Airline System - Samson AirLine AX1 Mode D'emploi

Setting up and Using your AirLine System

The basic procedure for setting up and using your AirLine System takes only a few minutes:
1. For your AirLine system to work correctly, both the receiver and transmitter must be set to the same channel. Remove all packing
materials (save them in case of need for future service) and check to make sure that the supplied receiver and transmitter are set to
the same channel (a complete channel plan is printed on the inside back cover of this manual). If these channels do not match,
contact your distributor or, if purchased in the United States, Samson Technical Support at 1-800-372-6766.
2. Place a fresh AAA alkaline battery in the AM1's battery compartment, taking care to observe the polarity markings, and physically
place the receiver where it will be used (the general rule of thumb is to maintain "line of sight" between the receiver and transmitter
so that the person using or wearing the transmitter can see the receiver). The AM1 can be mounted on hot shoe of a video camera
using the supplied hot shoe clip, worn as a belt pack using the belt clip or fixed to any location with the supplied velcro.
3. Bend the antenna in a vertical position. Make sure the Power on-off switch in your transmitter is set to "Off."
4a. If your system contains an AX1 handheld transmitter, unscrew the bottom section by turning it counterclockwise and then slide it off.
4b. If your system contains an AL1 body pack transmitter, turn it over and slide off the battery door.
5. Place a fresh AAA alkaline battery in the transmitter battery compartment, taking care to observe the polarity markings. If you are
using an AX1 transmitter, replace the bottom section by sliding it on and then screwing it back on. If you are using an AL1 trans-
mitter, replace the battery door by sliding it in until it clicks. Whichever transmitter you are using, leave it off for the moment.
11
Samson AirLine