Eurosystems ABR66 Manuel D'utilisation page 17

Checking the tightness of
fasteners and guards
Cleaning
Greasing
Blade adjustment
Blade replacement
Blade sharpening
Excessive blade clearance, correct the blade clearance
Blade not sharpened, re-sharpen the blade
Irregular grass
Damaged /worn blade, replace the blade
cutting
Excessively flattened grass, change cutting entry direction
Excessively wet grass, let it dry out
Cables are not properly connected, check the transmission cables
The cutting bar is not
working
Belt broken.
Cutter bar does not Demaged spring, replace it
stop when releasing
Disconnected spring, connect it properly
the related lever
Contact the nearest authorised service centre if the problem cannot be solved.
13. ADDITIONAL INSTRUCTIONS
13.1 DISPOSAL
At the end of its life cycle, the product
must be disposed of in accordance with
the regulations in force for Differentiated
waste disposal and cannot be treated as
simple urban waste.
The product must be disposed of at ded-
icated collection points or must be re-
turned to the dealer if you wish to replace
the product with another new equivalent
product.
The product is composed of non-biode-
gradable parts and substances that can
pollute the surrounding environment if not
properly disposed of. In addition, some of
these materials can be recycled to avoid
environmental pollution. It is everyone's
duty to contribute to the health of the en-
vironment.
When present, the symbol
11. MAINTENANCE PLAN
Always before starting the machine - check that there are no untightened
screws, bolts and/or nuts and that the bonnets and protection systems are
intact and correctly fitted.
After each use
After each use and after each wash
When cutting is not effective due to too much clearance between the two
blades
When blade sharpening is no longer possible or when a dent cannot be
fixed by sharpening
Loss of blade cutting edge or dent
12. TROUBLESHOOTING
Possible cause
the electrical and electronic equipment
that must be disposed of separately as
prescribed by standards 2002/95/EC,
2002/96/EC and 2003/108/EC. Do not
dispose of this equipment in unsorted
municipal waste, but take it to appropriate
separate collection areas.
Ask your local authorities for information
about waste disposal areas.
Anyone who does not dispose of the prod-
uct in accordance with this paragraph is
responsible for it in accordance with the
regulations in force.
13.2 DECOMMISSIONING
AND DISMANTLING
The decommissioning and dismantling of
the Machine and/or the interchangeable
equipment covered by this user's manual
consists in the disassembly of the product
by authorised personnel in compliance
identifies with the provisions of Legislative Decree
How often
81/08 (use of PPE, etc.) and the subse-
quent sorting and disposal as reported
in the "DISPOSAL" paragraph of this Use
and maintenance manual.
See chapt.
-
10
9.1
9.2
9.3
9.4
See chapt.
9.2
9.4
9.3
-
-
-
Contact a special-
ised workshop.
6
6