Storage - Scheppach CSH46 Traduction Des Instructions D'origine

General Complete chainsaw
Saw chain
Chain brake
Guide bar
Before start up Saw chain
Guide bar
Chain lubrication
Chain brake
STOP switch, safety shut-off
button, throttle lever
Fuel tank and oil tank caps
Daily Air filter
Guide bar
Guide bar mount
Idle speed
Weekly Fan housing
Cylinder area
Spark plug
Silencer
Protective sleeve for chain
trap
Screws and nuts
Quarterly Suction head
Fuel tank, chain oil tank

Storage

Complete chainsaw
Saw chain and guide bar
Fuel tank, chain oil tank
Carburettor
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables.
Wear parts*: Chain chain, guide rail, chain oil, engine
oil, nail clasp, chain catcher, spark plug, air filter, fuel
filter, chain oil filter
* Not necessarily included in the scope of delivery!
10. Storage
m CAUTION
Never put a chain saw into storage for longer than 30
days without carrying out the following steps.
Follow the cleaning instructions and maintenance in-
structions before storing the device.
52 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Clean the exterior and check for damage
In the event of damage, have a professional repair carried
out immediately
Sharpen regularly, replace in good time
Have it checked in a specialist workshop at regular intervals
Turn so that the running surfaces wear evenly. Replace in
good time
Check for damage and sharpness
Check chain tension
Check for damage
Functional check
Functional check
Functional check
Check sealing
Clean
Check for damage, clean oil inlet hole
Clean, in particular the oil guide groove
Check (saw chain shall not run)
Clean in order to ensure trouble-free routing of cooling air
Clean
Check, replace if necessary
Check for clogging
Check for damage, replace if necessary
Check condition and firm seating
Replace
Clean
Clean the exterior and check for damage
In the event of damage, have a professional repair carried
out immediately
Remove, clean and oil lightly
Clean guide bar guide groove
Empty and clean
Run until empty
Storing a chain saw
Storing a chain saw for longer than 30 days requires
storage maintenance. Unless the storage instruc-
tions are followed, fuel remaining in the carburetor
will evaporate, leaving gum-like deposits. This could
lead to difficult starting and result in costly repairs.
• Remove the fuel tank cap slowly to release any
pressure in tank. Carefully drain the fuel tank.
• Start the engine and let it run until the unit stops
to remove fuel from carburetor.
• Allow the engine to cool (approx. 5 minutes).
• Remove the spark plug.
• Pour 1 teaspoon of clean 2-cycle oil into the com-
bustion chamber. Pull starter rope slowly several
times to coat internal components. Replace spark
plug.
m NOTE
Store the unit in a dry place and away from possible
sources of ignition such as a furnace, gas hot water
heater, gas dryer, etc.