Advanced Programming; Setting The Language; Setting The Setpoint - aqua DGTEC CD Mode D'emploi

dGdoser Model
Programmable digital peristaltic pump

3.3 ADVANCED PROGRAMMING

Here below are the various features of the Programming Menu in greater detail.
Every parameter that is changed in the pump's programming is saved when you go back to the initial
display. If the pump's power supply is disconnected before going to the stand-by display, programmed
data is lost.
3.3.1 S L
ETTING THE ANGUAGE
From the LIn entry you can choose between Italian It and English En via the ▲ ▼ keys. Use Enter
exit.
(Fig. 12)
3.3.2 S S
ETTING THE ETPOINT
Set-point is the conductivity value obtained from the tank once the g/l of optimal detergent has been dissolved to
execute the wash.
From the Con entry, it is possible to access the following sub-menu: (Fig. 13):

LEt: displays the conductivity value read by the probe, in units from 0 to 100; by pressing the F key for 3
seconds, you may set the read value as a Set-point value;
 SEt: allows you to display and if necessary change, via the ▲ and ▼ keys, the conductivity Set-point value
from 0 to 100 units;
ADSP7000634
Fig. 11 - Standard programming from User Menu
Fig. 12 - Programming the Language
rev. 1.2
INSTRUCTION AND MAINTENANCE MANUAL
30/06/2014
ENGLISH
to enter and
48/206