Krick Florida Mode D'emploi page 36

Fig. frame foot with pin
Fig. Half seat frame
Now put 2 frame feet together for soldering.
Make a soldering jig from a plywood board and
strips.
Now the footrests can be soldered in. Make the
seat frame 4 times, 2 for each seat.
2 mm
Fig. half seat frame soldered
Now drill 2 holes Ø 2mm at a distance of 21.5
mm.
Now the seat frame can be put together for
soldering.
A soldering jig is again helpful for this. (In the
following figure is an example with dimensions
for the soldering jig)
Status April 2020
Fig. pins for soldering the support 7.23
Insert the connectors part 7.24. Fit and insert
the support part 7.23.
Now solder the seat frame completely.
If you cannot solder, the connectors can also
be glued. Here you can use 5 min epoxy.
Fig. seat frame with feet
After soldering the feet part 7.25 sand all sol-
dering points. Now the seat frame can be
painted. A chrome lacquer can be used.
Now the seat shell and the seat frame can be
glued together.
21,5 mm
Fig. finished seat
Seite 14
7.24
32 mm
©
Krick Modelltechnik, Knittlingen, Germany
20 mm
7.25